Print Site File - GE Panametrics GF868 Programming Manual

Print Site File

Printing Data
Use the PROG submenu to print the data in a site file that was set up
and saved as described in Chapter 1, Programming Site Data. To
print a site file, refer to Figure A-5 on page A-5 of Appendix A, Menu
Maps and complete the following steps:
IMPORTANT: Make sure that a printer has been properly set up
before proceeding with this section.
1. To access the Print Menu, press the
Note: The Print Menu is not protected by the security feature and a
password is never required to access this menu.
2. Press = .
[F3] PROG
3. Use the [←], [→] and
to print.
Note: All site files currently in memory appear on the option bar.
The active site file is always listed as the first choice
The Model GF868 returns to the standard data display screen and
generates a site file printout similar to the one shown in Figure 4-5 on
page 4-11. The printout continues until the entire file has been printed
or until a command is issued (see the instructions for the
STOP
submenu on the next page.
PROGRAM PARAMETERS of Work
Model GF868 GF3G
With 8K FIFO and 1113 receiver board.
At 12:28:24 PM on 12 APR 99
ACTIVE PARAMETERS:
Site status
Skan/measure mode
SYSTEM PARAMETERS:
no label
System Units
Totalizer Option
Volumetric Units
Volumetric Time
VOL Decimal Digits
Totalizer Units
TOT Decimal Digits
Mass Flow Units
MDOT Decimal Digits 0
Mass Units
Mass Decimal Digits 0
PIPE PARAMETERS:
Transducer number
Pipe OD
Pipe Wall
Path Length
Axial Dimension L
Multi K-factors
Calibration Factor
Figure 4-5: A Typical Site File Printout
key.
[PRNT]
[F1]-[F4] keys to select the desired Site File
Burst
Skan Only
No message
ENGLISH
Automatic
Thousands ACF
/min
0
Actual cubic ft
0
Pounds
Pounds
81
12.000 inches
0.200 inches
16.97 inches
12.00 inches
OFF
1.000
March 2003
.
(Work)
STOP
4-7