Saving Site Data - GE Panametrics GF868 Programming Manual

Saving Site Data

Programming Site Data
The currently programmed site data may be stored in the Model
GF868's non-volatile memory by saving it as a site file. Up to ten site
file names, consisting of up to five characters each, may be stored at
any given time. While following the programming instructions, refer
to Figure A-3 on page A-3 of Appendix A, Menu Maps. Enter the
submenu by pressing [→] and
SAVE
screen and complete the following steps:
1. Enter a new site file name and press
and keys to select and overwrite an existing site file.
[F1]-[F4]
Note: The option bar will show only as many choices as there are
existing site files.
If ten site files are already stored in memory, an existing site file must
be deleted before a new site file name can be assigned. See Chapter 5,
Clearing Data, for details.
When a site file is stored in memory, it becomes the active site file
until another site file is created or retrieved. (See the next section for
instructions on retrieving a site file.) To verify that the site file has
been saved, use the [↑] key to scroll back to the
and see if the name appears on the option bar (use the [←] and [→]
keys to scroll through the list, if necessary). Whenever a new site file
name is saved, it is automatically assigned to the next available
function key. Press [EXIT]
2. Use the [←] and [→] and
press to leave the User Program and return to measurement
[EXIT]
mode.
at the initial User Program
[F4]
, or use the [←], [→]
[ENT]
SITE NAME
to leave the SAVE submenu.
keys to select another menu, or
[F1]-[F4]
March 2003
prompt
1-35