Start Date Prompt; End Time Prompt - GE Panametrics GF868 Programming Manual

March 2003
STARTTIME Prompt
(cont.)

START DATE Prompt

END TIME Prompt

3-4
a. Press [F1]-[F2] to select
Hour (1-12) and press
the current time will generate an error message.)
b. Enter the desired Minutes and press
range is 0 to 59.
c. Enter the desired Seconds and press
range is 0 to 59.
11. Press to accept the displayed Start Date or press
[F1]
a different start date. To start logging today, press
•
If or was selected, proceed to step 12 for a non-
OK TODAY
circular log or to step 13 for a circular log.
•
Otherwise, complete the following steps to Edit the Start Date.
a. Enter the desired Year and press
0 to 99.
b. Use the [←], [→] and
Month.
c. Enter the desired Day and press
1 to the number of days in the selected month (28, 29, 30 or
31).
12.Press [F1] to accept the displayed End Time or press
different end time. To select a specific time period for the log to
run, press .
[F3]
•
If was selected, proceed to the
OK
•
If TIMED was selected, proceed to the
•
If EDIT was selected, complete the steps on the next page.
Note: The log
END TIME
least five minutes. Failure to observe this restriction will
result in an error message.
AM or PM . Then, enter the desired
. (Entry of a start time earlier than
[ENT]
[ENT] . The acceptable
[ENT] . The acceptable
. The acceptable range is
[ENT]
keys to select the desired
[F1]-[F4]
. The acceptable range is
[ENT]
END DATE
LOG TIME
must exceed the log START TIME
to enter
[F2]
.
[F3]
[F2] to enter a
prompt.
prompt.
by at
Logging Data