What's Next - GE Panametrics GF868 Programming Manual

March 2003
Entering the Pressure
Input (cont.)

What's Next?

1-22
•
If you selected SLOT X,
a. Press to select input A or press
[F1]
inputs were labeled during setup.
b. Enter the Base Pressure (standard) value for the process, and
press the key. (The meter will only accept values from
[ENT]
0–5000 psia.)
IMPORTANT: If an installed option card does not appear on the
option bar for the TEMPERATURE INPUT or
PRESSURE INPUT, the card may not have been
initialized or it may be defective. Call the factory for
assistance.
6. At the N2 Input prompt, press
percentage or press
[Fx]
supply the live N percentage.
2
7. Do one of the following:
•
If you selected FIXED, enter the known fixed N
Press . (The meter will accept values from 0 to 100
[ENT]
percent.)
•
If you selected SLOT X,
a. Press to select input A or press
[F1]
inputs were labeled during setup.
After completing the above steps, the meter returns to the main I/O
prompt. Continue as follows:
•
To continue programming the meter, press [EXIT] to return to
the User Program. Refer to the menu maps in Appendix A and
navigate to the desired menu. Then, proceed to the appropriate
section of the manual for instructions.
•
To leave the User Program and retain the previous settings,
press [EXIT] and then press
programming changes will be discarded and you will be
returned to the data display.
•
To leave the User Program and return to measurement mode,
press and then press
[EXIT]
Your programming changes will be entered into the meter's
memory, and you will be returned to the data display.
to select input B.The
[F2]
[F1] to enter a constant N
to select the option card in Slot x that will
to select input B.The
[F2]
[F1] = NO at the SAVE prompt. Any
at the SAVE prompt.
[F2] = YES
Programming Site Data
2
percentage.
2