GE Panametrics GF868 Programming Manual page 61

March 2003
Displaying the
Transducer Signal
(cont.)
2-12
107 686.798mi
S
U
P
ST: 594.298usec
<CURS CURS> <PAGE PAGE>
The typical display screen shown has the
to the left of the y-axis and there is a message line below the graph
that initially indicates the starting date and time of the graphed signal.
Notice that most of the locator bar has been replaced by a status line
in standard video that shows the signal amplitude and the time (in
microseconds) of the measurement at the current cursor location.
However, there is still an inverse video pointer at the far right of this
line to indicate that additional option bar choices are available.
Table 2-6: Graphical Log Display Options
Option Bar Choice
=
[F1] <CURS
=
[F2] CURS>
[F3] = <PAGE
=
[F4] PAGE>
→]
[ + [F1] = START
→]
=
[ + [F2] END
→]
=
[ + [F3] YMAX
→]
[ + [F4] = T INC
←]
=
[ + [F1] EXIT
Use the [←], [→] and
keys to select the desired option.
The options are listed in Table 2-
6 below.
Sup transducer signal listed
Description
Move the cursor to the left and display the
amplitude and time in the status line:
(i.e. )
107 686.798mi
Move the cursor to the right and display
the amplitude and time in the status line:
(i.e. 107 686.798mi )
Display the previous page
Display the next page
Move the cursor to the start of the current
page and post the starting date and time in
the message line: (i.e. ST: 451.798usec
Move the cursor to the end of the current
page and post the ending date and time in
the message line:
(i.e.
END: 744.298usec
Display the maximum Y value, which is
set to 128 divisions in arbitrary units, in the
message line.
Display the time increment value in the
message line. This is based on the fre-
quency of the transducers and would equal
0.125 µsec for a 1 MHz transducer.
Leave the graphical
SIGNL
return the display to the previous data for-
mat. (The [EXIT] key on the keypad will
also perform this function.)
[F1]-[F4]
)
)
display and
Displaying Data