Option Card Alarms - GE Panametrics GF868 Programming Manual

Setting Up Analog
Outputs (cont.)

Option Card Alarms

Programming Site Data
The DIAG option provides access to a wide variety of diagnostics
parameters. See Chapter 3, Diagnostics, of the Service Manual for a
complete description of these options.
4. Enter the Zero value for the low end of the chosen output range.
Press [ENT] .
5. Enter the Full value for the high end of the chosen output range.
Press [ENT] .
6. Use the [F1] - [F4] keys to set up another output or press
select another slot for setup.
For instructions on setting up additional inputs and/or outputs
proceed to the appropriate section. Otherwise, press
to the main I/O menu prompt.
1. Use the [F1]-[F3] keys to set up alarm relays A, B, or C,
respectively.
Note: The set up of alarm A is used as an example. Identical
procedures would be used to set up the other alarms.
2. Press = OFF to disable Alarm A and return to the previous
[F1]
prompt, or press [F2] = HIGH, [F3] = LOW or [F4]
specify the type for Alarm A.
3. Press [F1] = NO for standard operation or [F2] = YES for
Failsafe operation.
4. Do one of the following:
•
If you selected FAULT, proceed to step 5.
•
If you selected HIGH or LOW, complete the steps below.
a. Use the [←] and [→] and
Output Measurement parameter, as shown in Table 1-7 on the
previous page.
b. Enter a value for the trigger point of the alarm and press
5. To select the Fault Type that will trigger the alarm, press
FLOW , [F2] = OTHER
6. Press - to set up another alarm or press
[F1] [F3]
another slot for set up.
For instructions on setting up additional inputs and/or outputs
proceed to the appropriate section. Otherwise, press
to the main I/O menu prompt.
keys to specify the desired
[F1]-[F4]
(non-flow), or [F3]= ALL
March 2003
[EXIT] to
to return
[EXIT]
= FAULT to
.
[ENT]
[F1] =
.
to select
[EXIT]
to return
[EXIT]
1-17