Adjusting The Touch Screen - YOKOGAWA GX20 User Manual

1.29 Initializing and Calibrating the System (Initialization, reconfiguration, touch screen calibration), Setting the Measurement Mode
1.29.5

Adjusting the Touch Screen

IM 04L51B01-01EN
Note
• Do not carry out the following operations while the GX/GP is reconfiguring. Doing so may cause
damage.
Turn the power off and on.
Insert or remove modules.
• If turn off a expansion module and turn it back on, after checking the connected module,
execute reconfiguration.
• If the total number of I/O channels of the installed modules exceeds 100 on the GX10/GP10/
GX20-1/GP20-1 or 500 on the GX20-2/GP20-2, no additional modules can be reconfigured.
For example, if the maximum number of I/O channels are assigned and the last channel is
assigned to an intermediate channel of an installed I/O module, that module and subsequent
modules will not be reconfigured or identified.
Example GX10/GX20-1
Module
Maximum number 100
of I/O channels
106
• If the measurement mode is high speed, dual interval or if the advanced security function is
enabled, PID control modules will not be identified.
• During reconfiguration, the output channel is turned off or de-energized. In addition, for models
with the program control function (/PG), the program pattern is changed when the PID control
module is removed.
Conditions on the Combination of Firmware Versions and Modules
The module versions that can be detected depending on the firmware version are as follows.
If an installed module cannot be detected, update the firmware.
Name Model
Analog Input GX90XA -U2 (Universal)
Digital Input GX90XD
Digital Input/Output GX90WD
Digital Output GX90YD
Pulse Input GX90XP
Analog output GX90YA
PID control GX90UT
Expansion Module GX90EX
See page 5-18 in section 5.1.6, "Adjusting and Checking the Touch Screen".
Module
n 1
91 81 1
:
: :
• • •
:
90 10
This module will not be detected.
Module
Type
-T1 (Electromagnetic relay)
-C1 (Current (mA))
-L1 (Low withstand voltage)
-H0 (high-speed universal)
-R1 (4-wire RTD/resistance)
Index
Firmware Version
R1.01.X or later
R1.03.X or later
R2.01.X or later
R2.01.X or later
R4.01.X or later
R4.01.X or later
R1.01.X or later
R2.01.X or later
R1.01.X or later
R3.01.X or later
R3.02X or later
R4.01.X or later
R2.01.X or later
1-257
1
2
3
4
5
App