Setting Trend Display Conditions - YOKOGAWA GX20 User Manual

1.10 Setting Display Conditions
1.10.4

Setting Trend Display Conditions

Path
Description
1-114
GX/GP: MENU key > Browse tab > Setting > Setting menu Display settings > Trend
settings
Web application: Config. tab > Display settings > Trend settings
Hardware configurator: Display settings > Trend settings
Setup Item
Direction
Trend clear
Trend line
Grid
Direction
Set the trend waveform display direction.
Trend clear
Options
On
Off
Trend line
Set the trend waveform line width.
Grid
Select the number of grid lines to display in the waveform display area of the trend display.
Options
4 to 12
Auto
Scale
Setup Item
Digit
Value indicator
Digit of mark
Digit
The number of displayed digits.
Fine: If scale values are two digits, you can change them to display three digits.
For example, if the scale range is 49.0 to 51.0 and you select Normal, the scale values are
displayed using two digits ("49" for example). (
"Setting the Display".)
If you select Fine, the scale values are displayed using 3 digits as shown below.
Selectable Range or Options
Horizontal, Vertical
Off, On
Thick, Normal, Thin
Auto, 4, 5, 6, 7, 8, 9, 10, 11, 12
Description
Clears displayed waveforms when recording starts.
Does not clear displayed waveforms when recording starts.
Description
Displays a grid that divides the display width into 4 to 12 sections.
Divides the grid into the number of scale divisions of the first assigned
channel of the group.
Selectable Range or Options
Normal, Fine
Mark, Bar graph
0 digit, 3 digits, 4 digits
See the note in page 1-40 in section 1.2.3,
Default Value
GX20/GP20/GP10:
Horizontal
GX10: Vertical
Off
Normal
Auto
Default Value
Normal
Mark
3 digits
IM 04L51B01-01EN