JUMO 709061/8-01-032 Operating Manual page 55

Current measured val-
ue
Current deviation from
teach-in.
i.e. at > 0 %
the load has become
more high-resistance;
at < 0 % the load is
more low-resistance
V1.04/EN/00561071 [Thyristor Power Switch TYA 201]
0 to 9999.9 The absolute maximum limit values for load voltage, load current,
power, resistance, mains voltage, or device temperature can be mon-
itored.
v Chapter 5.1.5 "Monitoring"
Example:
An alarm is triggered if the voltage exceeds 100 V.
0 ...1 ... The switching differential at the minimum or maximum limit value
9999.9
0...10...100 Partial load failure or partial load short circuit:
%
The monitoring value for the percentage of change to the load is se-
lected (undercurrent or overcurrent).
v Chapter 5.1.5 "Monitoring"
By displaying the current deviation from the teach-in value, it is pos-
sible to check whether, for example, an output level-dependent resis-
tance modification is present.
k
/ bold = default setting
This function is not configured per default.
This window only appears if the following setting has been se-
lected in the configuration level:
h Press the
h Set Monitoring
r
Manual
h Press the
The "Manual teach-in" function is now configured.
h Change to the operating level
Teach-In
h Press the
A screen now appears asking whether the state should be ap-
plied now. If so:
h Press the
state.
A change in the load (load error) will be evaluated by the device
on the basis of this state.
k
/ bold = default setting
key to switch to the configuration level
r
Teach-In type load monit.
key
r
Monitoring
key
key to apply the current load state as the OK
4 Operation
r
Load monit.
53