Binary Signal For Collective Fault - JUMO 709061/8-01-032 Operating Manual

8.1 Binary signal for collective fault

V1.04/EN/00561071 [Thyristor Power Switch TYA 201]
This signal is used for controlling the digital output and LED K1, and can also
be read out from the power controller via the interfaces.
You can use the setup program to configure which events (alarm and error
messages) are to be grouped together as a binary signal for a collective fault.
All fault messages are OR-linked and output as a binary signal for a collective
fault on the relay output or optocoupler.
In addition, LED K1 lights up yellow.
This alarm can switch a relay at the binary output.
v Chapter 5.1.7 "Digital output"
8 Error messages and alarms
105