Typographical Conventions; Warning Symbols - JUMO 709061/8-01-032 Operating Manual

1 Introduction
E
When accessing the inner parts of the device and returning device plug-in
units, modules, or components, please observe the regulations according to
DIN EN 61340-5-1 and DIN EN 61340-5-2 "Protection of electronic devices
from electrostatic phenomena". Use only ESD packaging for shipment.
Please note that we cannot accept any liability for damage caused by ESD.
ESD=Electrostatic Discharge

1.2 Typographical conventions

1.2.1 Warning symbols

Caution
Warning
A
ESD
Dangerous volt-
age
Hot
surface,
fire hazard
8
V
This character is used if personal injury may result from failure to
follow instructions correctly or not at all!
This symbol is used when damage to devices or data may result
from failure to follow instructions correctly or not at all!
E
This character is used if precautionary measures must be taken
when handling electrostatically sensitive components.
This symbol is used if dangerous voltages will cause an electric shock
in the event of contact with live parts.
This symbol is used if burns can result from touching a hot surface.
Do not install any heat-sensitive components or devices close to the
power controller.
V1.04/EN/00561071 [Thyristor Power Switch TYA 201]