Safety information 1 Safety information General information This manual contains information that must be observed in the interest of your own safety and to avoid material damage. This information is supported by symbols which are used in this manual as indicated. Please read this manual before starting up the device.
Installation specifications for direct mounting 2 Installation specifications for direct mounting Plastic screw connection 1. Place the O-ring from the supplied set onto the assembly aid. 2. Place the O-ring with the assembly aid into the installation location using a rotating motion according to DIN EN 1434.
2 Installation specifications for direct mounting Brass screw connection Brass screw connection Assembly aid (depth stop for screw connection installation) Slotted pin Assembly aid (for positioning the O-ring) Preparing for installation 1. Fit the brass screw connection in the correct position on the temperature probe using a loosely placed slotted pin.
Page 7
2 Installation specifications for direct mounting Installation In measuring point M10 x 1 according to EN 1434 (ball valve, T-piece, adapter screw fitting or heat meter housing) O-ring Assembly aid Temperature probe with screw connection Measuring point according to EN 1434/M10 x 1 1.
Installation specifications for immersion sleeve 3 Installation specifications for immersion sleeve NOTE! Mounting in thermowell only with plastic screw connection. 1. Pinch together the plastic screw connection on the probe cable. Important: Do not mount the plastic screw connection into the recesses (beading) on the tempera- ture probe sleeve.
Page 10
JUMO GmbH & Co. KG JUMO Instrument Co. Ltd. JUMO Process Control, Inc. Street address: JUMO House 6733 Myers Road Moritz-Juchheim-Straße 1 Temple Bank, Riverway East Syracuse, NY 13057, USA 36039 Fulda, Germany Harlow, Essex CM 20 2DY, UK Delivery address:...