Xerox DocuCentre SC2020 User Manual page 165

Subnet Mask
Gateway Address
IPsec
Note: IPsec feature is available only when IPsec is enabled on CentreWare Internet Services.
Purpose: Disables IPsec.
Value:
Disable
Connection Speed
Note: Connection Speed feature is available only when the device is connected using the network.
Purpose: To specify the communication speed and the duplex settings of Ethernet. The change becomes
effective after the device is turned off and then on again.
Values:
Auto
10BASE-T Half
10BASE-T Full
100BASE-TX Half
100BASE-TX Full
Protocols
Purpose: To enable or disable each protocol. The change becomes effective after the device is turned off
and then on again.
When an IP address is being set manually, the subnet
mask is specified using the format "nnn.nnn.nnn.nnn".
Each octet that makes up "nnn.nnn.nnn.nnn" is a value in
the range of "0" to "255". "255.255.255.255" cannot be
specified as the subnet mask.
When an IP address is being set manually, the gateway
address is specified using the format "nnn.nnn.nnn.nnn".
Each octet that makes up "nnn.nnn.nnn.nnn" is a value in
the range of "0" to "254. "127" and any value in the range
of "224" to "254" cannot be specified for the first octet of
a gateway address.
Disables IPsec.
Detects the Ethernet settings automatically.
Uses 10BASE-T Half-duplex.
Uses 10BASE-T Full-duplex.
Uses 100BASE-TX Half-duplex.
Uses 100BASE-TX Full-duplex.
® ®
Xerox DocuCentre SC2020
User Guide
Tools
162