Table of Contents
Advertisement
Tools
5.
Select [Panel Lock].
6.
Select [Panel Lock Set].
7.
Select [Enable], and then select [OK].
8.
Enter the new passcode, and then select [OK].
Note:
The factory-default panel passcode is 0000.
–
Be sure to remember the passcode. The procedure described below allows you to reset the
passcode, but the settings for Address Book are cleared.
–
Turn off the device. Then, while holding the <Machine Status> button, turn on the device.
–
If you change the passcode while [Panel Lock Set] is [Enable], perform steps 1 to 3. Enter the
current passcode, and then select [OK]. Perform steps 4 and 5. Select [Change Passcode], and
then select [OK]. Enter the current passcode, and then select [OK]. Perform steps 8 and 9. This will
change the passcode.
217
®
Xerox
DocuCentre
User Guide
®
SC2020
- Quick Links:
- Error Code
Hide quick links:
Advertisement
Table of Contents
