Error Codes - Henny Penny 500 Technical Manual

1-4. WARNINGS AND
ERROR MESSAGES (Continued)
DISPLAY
"
E-41" Memory scrambled; an individual
"SYSTEM product program may be scrambled;
DATA LOST" ex:
means product #2 program is
scrambled
"E-46" Faulty eprom or PC board
"DATA SAVE
FAILED"
"E-47" Failure of 12 volt DC supply
"ANALOG on the I/O board
SYSTEM
OR 12 VOLT
FAILED"
Amp sensors plugged in backwards
Faulty PC board
"E-48" Failure of 12 volt DC supply
INPUT on the I/O board
SYSTEM
ERROR"
Faulty PC board
"E-70 A" Missing or broken wire in pins 1 and
"FAN VAC 2 of P11 connector, or faulty
JUMPER connector
MISSING"
Faulty I/O board
"E-70 B" Faulty COOK/PUMP switch
"PWR SW or switch wiring; faulty
OR WIRES I/O board
FAILED"
"E-92" Blown 24 volt controller fuse, or
"24 VOLT bad 14-pin cable connection
FUSE"
Stuck or clogged solenoid valve
205

ERROR CODES

CAUSE
"E-41 -2- DATA LOST"; this
CORRECTION
Turn the COOK/PUMP switch OFF and back
to COOK; if error code persists, have the PC
board checked or re-initialized
Turn the COOK/PUMP switch OFF and back
to COOK; if error code persists, have the PC
board checked or re-initialized
Turn the COOK/PUMP switch OFF and back
to COOK; if the and
light up when the 8888's are displayed, have the
I/O board replaced
Have positions of amp sensors checked
Have control panel replaced
Turn the COOK/PUMP switch OFF and back
to COOK; if the and
light up when the 8888's are displayed, have the
I/O board replaced
Have control panel replaced
Have jumper wire between pins 1 and 2
checked
Have I/O board checked and replaced if
necessary
Have COOKPUMP switch checked, along
with its wiring; have I/O board checked
Have the 14-pin cable connector checked or
have the fryer checked for a short to ground in
components such as the drain switch, solenoid,
or high limit and wiring
Have solenoid checked and cleaned
Model 500/600
DO NOT
DO NOT
1-15