Henny Penny 500 Technical Manual page 172

Gas Hose and Connection
Replace any gas connection that has a damaged hose, torn or damaged sheathing, or
damaged fittings or quick disconnects that no longer function properly. Replace any
damaged fittings or quick disconnects using appropriate pipe thread sealant that conforms to
local code. Below are guidelines from the manual as reference.
The gas fryer is factory available for either natural or propane
gas. Check the data plate on the right side panel of the cabinet
to determine the proper gas supply requirements. The minimum
supply for natural gas is 7 inches water column (1.74 kPa), and
10 inches water column (2.49 kPa) for propane.
A separate disconnect switch with proper capacity fuses or breakers
must be installed at a convenient location between the fryer and
the power source. It should be an insulated copper conductor
rated for 600 volts and 90
(15.24 m), use the next larger wire size.
Do not attempt to use any gas other than that
specified on the data plate. Incorrect gas supply
could cause a fire or explosion resulting in severe
injuries and/or property damage.
Please refer below for the recommended hookup of the fryer to
main gas line supply.
To avoid possible serious personal injury:
• Installation must conform with local,
state, and national codes, and be
in accordance with Canadian Gas
Authority Standard CSA B149-&
2, Installation Codes - Gas Burning
Appliances and in accordance with
Australian Gas Association current
edition of AS5601 Gas Installations.
• The fryer and its manual shutoff
valve must be disconnected from the
1219 US 35 West P.O. Box 60 Eaton, OH 45320 (937)456-8400 Fax (937)456-8402 www.hennypenny.com
If any of these conditions are found, take the fryer out of
service until a new gas connection (hose, fitting, quick
disconnect) can be installed. Always adhere to local code
upon installation of the gas connection.
C. For runs longer than 50 feet
o
Inspection 4
Rev. A