Preventive Maintenance Schedule; Removing The Control Panel - Henny Penny 500 Technical Manual

2-3. PREVENTIVE
MAINTENANCE
SCHEDULE
2-4. REMOVING THE
CONTROL PANEL
2-2
To ensure a long life of the fryers and their components, regular
maintenance should be performed. Refer to the chart below.
Frequency
Daily (3-4 loads)
Daily
30 Days
90 Days
90 Days
90 Days
Once a year
To replace parts inside the fryer you will often need to remove
the control panel. The following steps provide the correct
procedure:
Removal
1. Place the main power switch to the OFF position.
(This switch is labeled COOK/OFF/PUMP.)
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
Step 2
breaker, or unplug cord at wall receptacle.
2. Remove the screws from the of the control panel.
3. With the fryer door partially closed, place the lower edge of
control panel in the slot between the door and the frame
of the fryer.
Step 3
Action
Filter shortening
Clean deadweight valve cap,
weight, and orifice
Lubricate spindle threads and ball seat
Reverse lid gasket
Check limit stop adjustment
Check and tighten element spreaders
Annual preventive maintenance
(see Appendix A.)
Model 500/600
305