Henny Penny 500 Technical Manual page 56

2-8. HEATING ELEMENTS
(ELECTRIC MODELS)
(Continued)
(Reference Figure 3-16)
2-10
Replacement
1. Drain the shortening.
2. Remove the high limit bulb holder from the heating
element inside the frypot.
3. Remove the heating element wires from the terminals by
removing nuts (5) and washers (6 and 7). Label each
so it can be replaced in the same position on the new
element.
4. Loosen the bolts on the four element spreaders.
5. Slide the element spreaders to the center of the heating
element.
6. Remove the brass nuts (4) and washers (3), which
secure the ends of the elements through the frypot wall.
7. Remove the heating elements from the frypot as a group
by lifting the far end and sliding them up and out toward
the rear of the frypot.
Always install new rubber O-rings (2) when installing
heating elements.
8. Install new heating elements with new rubber O-rings (2)
mounted on terminal ends, and spreaders loosely
mounted in the center of the stacked elements.
9. Replace the heating elements, terminal end first at
approximately 45º angle, slipping the terminal ends
through the front wall of the frypot.
Model 500/600
305