Henny Penny 500 Technical Manual page 206

Cross Arm Component Safety Inspection
Figure 1.
A
B
E
C
D
Figure 3.
1219 US 35 West P.O. Box 60 Eaton, OH 45320 (937)456-8400 Fax (937)456-8402 www.hennypenny.com
Figure 2.
A Acme Nut
B Idle Nut
C Locking Collar
D Thrust Ball
E Locking Collar
Pin
1. Separate the lid and cross arm.
2. Inspect the cross arm as indicated in
figure 1. Cracks on the bottom surface of
the cross arm are acceptable, but
anything rounding the corners as shown
in figure 2, coming up the sides, or found
on top would fail inspection. If any
cracks are found in the top or sides of the
cross arm, the fryer would be taken out
of service until the lid assembly is
replaced.
3. Inspect to make sure all of the spindle
components are in place: acme nut, idle
nut, thrust ball, locking collar (figure 3).
Inspect the gap between the acme nut
and the idle nut. These two components
should be within 1/16" of each other. If
any of these components are excessively
worn, damaged or missing, this step of
the inspection would fail. The fryer
would be taken out of service until the
damaged or missing component is
replaced.
4. Inspect the locking collar pin (figure 3). If
the pin has shifted, is missing, broken,
take the fryer out of service until a new
pin can be installed and properly staked.
This pin should be staked on
each side to prevent it from
shifting. If this pin is not properly staked,
severe burns could result.
Inspection 25
Rev. B