Henny Penny 500 Technical Manual page 62

2-10. GAS BURNER
ASSEMBLY
(GAS MODELS)
(Continued)
Step 6 and 7
28 24
U-BOLT
TURN ROD
Step 5, 8 and 9
2-16
4. Remove wires from the gas control valve.
5. Disconnect gas supply line (28) from the connector (24) at
control valve. (Refer to photo below.)
Step 4
6. Loosen the two screws (13) on the heat shield deflector (9),
on the firebox and flue assembly and raise the deflector to its
highest position.
7. Retighten screws (13) to hold the heat shield deflector in the
high position.
8. Turn the filter valve rod to the OPEN position.
9. Remove u-bolt from rinse hose bracket.
Model 500/600
305