Migration Tower Spd Hardware; 2629 Spd Lan/Wan/Workstation Iop; 2810 Lan/Wan Iop - IBM eserver i5 Handbook

Draft Document for Review October 18, 2004

Migration tower SPD hardware

All of the IOPs described in the following sections were
marketing
marketed by IBM" on page 840. This section is included for reference purposes
to assist in planning system upgrades.
Important: Keep in mind that Eserver i5 520, 550, 570, and 595, and iSeries
800, 810, 825, 870, and 890 models do not support migration towers or SPD
hardware.
For SPD to PCI migration considerations, refer to:
http://www.ibm.com/servers/eserver/support/iseries/planning/

#2629 SPD LAN/WAN/Workstation IOP

This adapter uses one SPD slot. It supports up to three of the following IOAs:
#6149 16/4 Mbps Token Ring IOA
#6180 Twinaxial Workstation IOA (
#6181 ASCII Workstation Controller (
2001)
One #2629 supports any combination of adapters with one restriction. There is a
maximum of two LAN IOAs.
Up to seven #2629s can be placed into each #5072 1063 Mbps System Unit
Expansion Tower. The #2629 is not allowed in slot 14 of the #5072 1063 Mbps
System Unit Expansion Tower. No restrictions apply when using the #2629 with a
#5073 tower.
The #2629 was

#2810 LAN/WAN IOP

The #2838 PCI 100/10 Mbps Ethernet IOA is used in SPD cages for attaching
the #2838 PCI 100/10 Mbps Ethernet IOA or one of the #281x PCI ATM IOAs. It
is a high workload IOP and has configuration limitations.
The #2810 was
. For a list of withdrawn features, see "Products and features no longer
withdrawn from marketing
withdrawn from marketing
withdrawn from
withdrawn from marketing
withdrawn from marketing
on 31 May 2001.
on 31 May 2001.
iSeries I/O processors
5486IOp.fm
31 July 2001)
31 July
335