Verifying The Phone Startup Process - Cisco 7902G Administration Manual

Verifying the Phone Startup Process

Step 3
Step 4
Verifying the Phone Startup Process
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
3-10
Insert two screws into a wall stud, matching them to the two screw holes on the
back of the phone.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
After the Cisco Unified IP Phone has power connected to it, the phone begins its
startup process by cycling through the following steps.
Cisco Unified IP Phone 7902G
The phone uses a combination of the three LEDs (handset, Hold, and Menu
buttons) to indicate the phone startup process. After several minutes, startup is
complete and the phone is ready to use. When all of the LEDs are off, you will
hear a dial tone when you lift the handset. If the phone does not start up
successfully, see "Checking the Light Indicators on the
Cisco Unified IP Phone 7902G" section on page 7-18
7905G and 7912G
Cisco Unified IP Phone
The handset light strip, Hold button, and Menu button flash on and off
1.
simultaneously.
The LCD screen displays the Cisco Systems, Inc., copyright screen.
2.
The LCD screen displays these messages as the phone starts up:
3.
Configuring VLAN
•
Configuring IP via DHCP
•
Configuring CM List
•
Opening address (where address is the IP address of the
•
Cisco Unified CallManager server)
Registering
•
Chapter 3 Setting Up the Cisco Unified IP Phone
.
OL-8151-01