Understanding The Requirements For Installing And Configuring The Cisco Unified Ip Phone 7902G, 7905G, And 7912G - Cisco 7902G Administration Manual

Chapter 1 An Overview of the Cisco Unified IP Phone

Understanding the Requirements for Installing and Configuring the Cisco Unified IP Phone 7902G, 7905G, and 7912G

Understanding the Requirements for Installing and
Configuring the Cisco Unified IP Phone 7902G,
7905G, and 7912G
Note
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
From this site, you can view and order various user guides, including wallet cards.
For complete ordering information, see the
on page xvi.
In addition to providing documentation, it is important to inform users of
available Cisco Unified IP Phone features—including features specific to your
company or network—and of how to access and customize those features, if
appropriate.
For a summary of some of the key information that phone users need their system
administrators to provide, see
a Website."
Related Topic
Providing Information to Users Via a Website, page C-1
•
To install and configure the Cisco Unified IP Phone 7902G, 7905G, and 7912G,
you must configure some network settings, set up Cisco Unified CallManager,
and make changes locally on the phone.
Before you install a phone, even if it is new, upgrade the phone to the current
firmware image. For information about upgrading, refer to the Readme file for
your phone, which is located at:
http://www.cisco.com/cgi-bin/tablebuild.pl/ip-7900ser
See Table 1-2 for an overview of required procedures. For detailed information
about these procedures, refer to the sources shown.
You can specify additional configuration settings using profile files stored on the
TFTP server. For more information, see
Methods and Parameters."
"Obtaining Documentation" section
Appendix C, "Providing Information to Users Via
Appendix A, "Additional Configuration
1-13