Cisco 7902G Administration Manual page 167

Appendix A Additional Configuration Methods and Parameters
Table A-5 Network Parameters (continued)
Parameter Description
VLANSetting Specifies various VLAN
settings.
Nprintf IP address and port of a
server to which
Cisco Unified IP Phone
troubleshooting messages
are sent.
TraceFlags Enables specific trace
features.
1. CDP = Cisco Discovery Protocol
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
OL-8151-01
Usage
Bit map, as follows:
Bits 0–2—Designate 802.1Q priority for
•
signalling IP packets.
Bits 3–5—Designates 802.1Q priority for audio
•
voice IP packets.
Bits 6–17—Reserved for future use.
•
• Bits 18–29—User-specified 802.1Q VLAN id.
Bits 30–31—Reserved for future use.
•
The default setting is 0x0000002b.
Enter the extended IP address of the server to which
troubleshooting messages are sent and collected in a
log file.
The default value is 0, which specifies that no
messages are sent.
To collect troubleshooting messages, the
Note
prserv.exe tool must be running on the server
specified with this parameter.
For more information about using Nprintf and
preserv.exe to collect troubleshooting information, see
the "Logging Information for Troubleshooting"
section on page 7-13.
Bit map
Bit 0–31—Reserved for future use.
Should be set to zero (0). The default setting is
0x00000000.
Configuration Parameters
A-19