Configuring IP Settings
Step 6
Step 7
Assigning a Default Router
Using the Phone Configuration Web Page (Cisco Unified IP Phone 7902G, 7905G, and 7912G)
Step 1
Step 2
Step 3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SCCP), Cisco Unified IP Phones
4-22
Press Validat.
Press Save.
If you manually assign an IP address to the Cisco Unified IP Phone, you must
indicate the default router to be used. The default router provides connectivity to
the IP network beyond the subnet to which the phone belongs.
Before you can assign a default router, you must disable DHCP. For instructions,
see the
"Disabling DHCP" section on page
Procedure
Display the Phone Configuration web page.
For instructions, see the
Configuration Web Page" section on page
In the pane on the left under Change Configuration, click Network Parameters.
You may be prompted to enter a password.
The Network Parameters web page appears.
To set the route address, enter an address in the StaticRoute field and click Apply.
On the Cisco Unified IP Phone 7902G, you can also review phone settings using
the IVR system. For more information, see
Voice Response (IVR) System on the Cisco Unified IP Phone 7902G."
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
4-17.
"Accessing Network Settings through a Phone
4-3.
Appendix B, "Using the Interactive
OL-8151-01