Verifying the Phone Startup Process
Verifying the Phone Startup Process
Configuring Startup Network Settings
Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager
3-16
After the Cisco Unified IP Phone has power connected to it, the phone begins its
startup process by cycling through these steps.
These buttons blink or flash on and off:
1.
Handset light strip
–
Hold button
–
Applications Menu button
–
2.
The screen displays the Cisco Systems, Inc., logo screen.
These messages appear as the phone starts:
3.
Configuring IP
–
Updating CTL
–
Verifying Load
–
Configuring CM List
–
Registering
–
The main LCD screen displays:
4.
Current date and time
–
Directory number
–
Softkeys
–
If the phone successfully passes through these stages, it has started up properly.
If the phone does not start up properly, see the
section on page
9-2.
If you are not using DHCP in your network, you must configure these network
settings on the Cisco Unified IP Phone after installing the phone on the network:
IP address
•
IP subnet mask
•
Default gateway IP address
•
Chapter 3
Setting Up the Cisco Unified IP Phone
"Resolving Startup Problems"
OL-10008-01