Ovislink OV804WV User Manual page 86

Step 3 In the ATM PVC Configuration page, set VPI/VCI to
3/35 and click Next.
Step 4 In the Connection Type page, select IP over ATM
(IPoA)
LLC/SNAP-ROUTING, and then click Next.
Step 5 In the WAN Settings page, enter the IP address,
subnet mask, and DNS server address provided by
your ISP. Do not select Use the following default
gateway. Then, click Next.
 WAN IP address: 20.1.1.2
 WAN subnet mask: 255.255.255.0
 Primary DNS server: 168.95.1.1
 Secondary DNS server: 168.95.192.1
Step 6 In the Network Address Translation Settings page,
enable the NAT and firewall. Keep default settings for
other fields. Then, click Next.
Step 7 Confirm the network configuration and ensure that all
settings are consistent with the data provided by your
ISP. Then, click Save.
Step 8 Click Save/Reboot to apply the changes and reboot
the DSL Router.
You can also modify the PVC 3/35. Modify the LAN IP address
and DHCP server information in LAN of Advanced Setup.
After the configuration is complete, the DSL Router WAN-side
interface is ipa_3_35.
If Enable NAT check box is disabled during the configuration,
you must configure the route on the BRAS. Otherwise, you
cannot access your ISP. In actual application, Enable NAT
must be selected.
4.4.1.10 Adding a Bridge PVC
This section describes the procedure for adding PVC 4/35
(IPoA mode).
Click Add and the following page appears.
and set the
82
Encapsulation Mode to