Ovislink OV804WV User Manual page 80

If Enable NAT is disabled during the configuration, you must
configure the route on the BRAS. Otherwise, you cannot
access your ISP. In actual application, Enable NAT check box
must be selected.
4.4.1.8 Adding an IPoA PVC
This section describes the procedure for adding PVC 3/35
(IPoA mode). Click Add and the following page appears.
Figure 60 PVC and its QoS configuration
In this page, you can modify VPI/VCI, service category, and
QoS.
VPI (Virtual Path Identifier): Virtual path between two points in
an ATM network. Its valid value range is from 0 to 255.
VCI (Virtual Channel Identifier): Virtual channel between two
points in an ATM network. Its valid value range is from 32 to
65535 (1 to 31 are reserved for known protocols).
VLAN Mux: Config VlanID over a single pvc
Service Category: UBR Without PCR, UBR With PCR, CBR,
Non Realtime VBR, and Realtime VBR.
Enable Quality of Service: Enable or disable QoS.
76