Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ovislink OV704WVG
Summary of Contents for Ovislink OV704WVG
- Page 1 OvisLink OV704WVG Quick Installation Guide...
-
Page 4: Hardware Description And Installation
Hardware Description and Installation Note: The figures in this document are for reference only. Hardware Description Figure 1 Front panel The following table describes the indicators on the front panel. Indicator Color Status Description The device is powered on and the device operates normally. - Page 5 Indicator Color Status Description Device is powered off. Internet synchronized successfully in the route mode. Internet data being Green Blink transmitted. Internet Ethernet interface disconnected. Authentication has failed. The WAN interface is connected to the Ethernet cable. Green Blink Network data is transmitting. interface connected to the Ethernet cable.
- Page 6 Indicator Color Status Description Connection succeeds under Wi-Fi Protected Setup. Negotiation is in progress under Green Blink Wi-Fi Protected Setup. Wi-Fi Protected Setup disabled. The connection of 3G or USB flash disk has established. USB1/2 Green Blink Data is being transmitted. No signal is detected.
- Page 7 Rear Panel and Side Panel Figure 3 Side Figure 2 Rear panel panel...
-
Page 8: Interface Description
The following table describes the interfaces and the buttons. Interface Description RJ-11 port. Connect the router to DSL connector or splitter through telephone cable. RJ-11 port, using the telephone cable to Phone1/2 connect the telephone set. RJ-45 port, for connecting the router to a PC or LAN 4~1 another network device. -
Page 9: Hardware Installation
Warning: Do not press the Reset button unless you want to clear the current settings. The Reset button is in a small circular hole on the rear panel. If you want to restore the default settings, please press the Reset button gently for 1 second with a fine needle inserted into the hole and then release the button. -
Page 10: Connecting The Device
types of materials and background RF noise in your home or business. Connecting the Device Step 1 Connect the DSL port of the router and the Modem port of the splitter with a telephone cable; connect the phone to the phone port of the splitter through a cable;... -
Page 11: Pc Network Configuration
Figure 4 Connecting the DSL router Note: If you use 3G WAN service, connect the 3G USB data card to the USB port of the router. PC Network Configuration Windows XP System Step 1 Choose Start > Control Panel > Network Connections. - Page 12 Step 4 Select the Obtain an IP address automatically button. Step 5 Select Obtain server address automatically button. Step 6 Click OK to save the settings. Win7 and Win8 System Set a fixed IP address Step 1 Choose Start > Control Panel > Network and Internet >...
- Page 13 Step 2 Choose Change Adapter Settings > Local Area Connection. Right-click Local Area Connection, and choose Properties. Step 3 Double-click Internet Protocol Version (TCP/IPv4). Step 4 Select Obtain an IP address automatically and Obtain DNS server address automatically, and then click OK.
- Page 14 Note: It is suggested to disable the Wi-Fi before configuring the wired connection. Wireless Connection XP, Win7 and Win8 system Step 1 Turn on the Router. The WLAN is enabled by default. Step 2 Enable the wireless network adapter on your PC and ensure that the Wireless Zero Configuration tool is available.
- Page 15 Step 4 Click the Status check box to turn Wi-Fi on, select the SSID from the wireless network list, and then click Apply. Step 5 Enter the password and click Join. Quick Configuration Step 1 Click the Wi-Fi icon on the top of desktop and select Turn Wi-Fi on.