Ovislink OV804WV User Manual page 122

Select Advanced Setup > Quality of Service and the
following page appears.
Figure 102 QOS queue management configuration
Select Enable QoS to enable QoS and set the default DSCP
mark.
Click Save/Apply to activate QoS.
4.4.5.2 QoS-Queue Configuration
The queuing in packet QoS becomes effective only when
packet is forwarded to QoS-enabled PVC. Packet forwarding is
determined by IP routing or bridging, not under control of the
packet QoS.
Click Queue Config, and the following page appears. In this
page, you can configure QoS queue. A maximum of 24 entries
can be configured.
QoS Queue Configuration can allocate four queues. Each of
the queues can be configured for a precedence value (Lower
integer values for precedence imply higher priority for this
queue relative to others). The queue entry configured is used
by the classifier to place ingress packets appropriately.
118