Ovislink OV804WV User Manual page 55

Step 2 To add an ATM PVC, click Add.
Step 3 To delete a PVC, select the Remove check box in the
table and click Remove.
Step 4 Click Save/Reboot to apply the changes and reboot
the DSL Router.
Note: After a PVC is deleted or modified, the system must be
rebooted. Otherwise, the modification does not take
effect.
The procedure for adding a PVC is described as follows.
4.4.1.1 Adding a PPPoE PVC
This section describes the procedure for adding PVC 8/35
(PPPoE mode).
Step 1 Click Add and the following page appears. In this page,
you can modify VPI/VCI, service category, and QoS.
Figure 39 PVC and its QoS configuration

VPI (Virtual Path Identifier): virtual path between two
points in an ATM network. Its valid value range is from 0 to
255.

VCI (Virtual Channel Identifier): virtual channel between
two points in an ATM network. Its valid value range is from
32 to 65535 (1 to 31 are reserved for known protocols).
51