Ovislink OV804WV User Manual page 65

Step 3 In the ATM PVC Configuration page, set VPI/VCI to
8/35 and click Next.
Step 4 In the Connection Type page, select PPP over
Ethernet (PPPoE) and set the Encapsulation Mode to
LLC/SNAP-BRIDGING, and then click Next.
Step 5 In the PPP User name and Password page, enter the
user name and password provided by your ISP.
IMPORTANT: Select Enable PPP IP extension.
Step 6 Click Next.
Step 7 In the Enable IGMP Multicast and WAN Service page,
keep the default settings and click Next.
Step 8 Confirm the network configuration and ensure that all
settings are consistent with the data provided by your
ISP. Then, click Save.
Step 9 Click Save/Reboot to apply the changes and reboot
the DSL Router.
Modify the LAN IP address in LAN in Advanced Setup.
After the PPPoE dial-up which is built in the DSL Router is
successful, the IP address 10.28.106.82 is obtained.
4.4.1.4 Adding a PPPoA PVC
This section describes the procedure for adding PVC 1/35
(PPPoA mode).
Click Add and the following page appears.
In this page, you can modify VPI/VCI, service category, and
QoS.
61