WPA. Client stations must use the same key in order
to connect with this device. Check the table below for
instructions when entering the key.
Format
ASCII
Hexadecimal
WPA2
–
Disenable.
Network Re-auth Interval: Specify the timer of
–
re-authentication between the server and the client.
WPA Group Rekey Interval: specifies the timer the
–
WPA key must change. If the value is set to 0, there
is no need to change. The change is done
automatically between the server and the client.
Radius Server IP Adress: Enter the IP Address of
–
the authentication server.
Radius Port: Enter the port number of the
–
authentication server. The default port number is
1812.
Radius Key: Enter the same key as the Radius
–
server's.
WPA Encryption: Select TKIP, AES, or TKIP + AES.
–
AES is default. The TKIP + AES encryption mode
means AP auto adjust to use TKIP or AES according
to wireless clients.
Click Save/Apply to save the wireless security options and
make the changes take effect.
Minimum characters
8
8
Preauthentication:
Maximum Characters
63
64
Select
172
Enable
or