Ovislink OV804WV User Manual page 63

Setting Procedure
Step 1 Open the Internet browser and enter 192.168.1.1 in the
address bar to log in to the DSL Router.
Step 2 Choose Advanced Setup > WAN and click Add.
Step 3 In the
and click Next.
Step 4 In the Connection Type page, select PPP over
Ethernet (PPPoE) and set the Encapsulation Mode
to LLC/SNAP-BRIDGING, and then click Next.
Step 5 In the PPP User name and Password page, enter the
user name and password provided by your ISP. Then,
click Next.
Step 6 In the Enable IGMP Multicast and WAN Service page,
keep the default settings and click Next.
Step 7 Confirm the network configuration and ensure that all
settings are consistent with the data provided by your
ISP. Then, click Save.
Step 8 Click Save/Reboot to apply the changes and reboot
the DSL Router.
You can also modify the PVC 8/35. To modify the LAN IP
address and DHCP server information, set in LAN in
Advanced Setup.
After the dial-up is successful, the DSL Router obtains the IP
address at the WAN-side port ppp_8_35_1.
Choose Device Info > Route and the route table is as follows:
ATM PVC Configuration
page, set VPI/VCI to 8/35
59