To Select The Default Disk - Agilent Technologies 35670A Quick Start Manual

Setting Up

To select the default disk

1
Press [ ] [
Disk Utility
DEFAULT DISK
or
Press [ ] [
Save/Recall
DEFAULT DISK
2
Press [
NON-VOL RAM DISK
or
Press [
VOLATILE RAM DISK
or
Press [
INTERNAL DISK
or
Press [
EXTERNAL DISK
Your default disk selection tells the analyzer which disk to use when it is saving and
recalling files. You can use online help to learn more about these options, but here is
an overview:
•
[
NON-VOL RAM DISK
approximately 100 Kbytes of storage space for data. (Option UFF adds an
additional 1 Mbytes of non-volatile RAM.) The data is not lost when you turn off
the analyzer.
•
[
VOLATILE RAM DISK
you turn off the analyzer. However, you can format the disk to hold more data than
the non-volatile RAM disk, and file operations are much faster than on the internal
disk.
•
[ ] selects the analyzer's internal disk drive. The internal disk uses
INTERNAL DISK
3.5-inch flexible disks (double-sided, double- or high-density). For more
information, see "To format a flexible disk" later in this book.
•
[ ] selects an external GPIB disk. (You must specify a disk unit
EXTERNAL DISK
number with the [
EXTERNAL DISK UNIT
drive in the [
Local/GPIB
must be set as the [
addresses, see online help.
16
].
].
]
]
]
].
] selects the analyzer's battery-backed RAM disk. There is
] selects the analyzer's volatile RAM disk. Data is lost when
] softkey.) Enter the address of the disk
] menu with the [
DISK ADDRESS
]. For more information on setting
SYSTEM CONTROLLER
Agilent 35670A Quick Start Guide
] softkey. The analyzer