Agilent Technologies 35670A Quick Start Manual page 47

Agilent 35670A Quick Start Guide
5
Configure the display.
Press [ ], then press[
Scale
6
Measure the signal source.
Press [ ].
Start
The default number of averages is 10. To specify a different number of averages,
press [ ] [
Avg
NUMBER AVERAGES
The average count at the bottom of the display is updated after each average.
Resolution can be set to 100, 200, 400 or 800 lines. Press
[ ] [
Freq
RESOLUTN (LINES)
The lines of resolution appears at the top of the display.
The analyzer has an input impedance of approximately 1 Megohm. If your signal
source needs to be terminated with a lower impedance, use an appropriate feedthrough
terminator between the output of the signal source and the Channel 2 input.
] to highlight ON.
AUTOSCALE ON OFF
] <number> [
ENTER
] <number> [ ].
ENTER
Making Measurements
].
29