Agilent Technologies 35670A Quick Start Manual page 5

Agilent 35670A Rear Panel
1-
The GPIB connector links the Agilent 35670A
to other GPIB devices. GPIB parameters are set in
the [ Local/GPIB ] and [ Plot/Print ] menus.
2-
The SERIAL PORT and the PARALLEL
PORT link the analyzer to plotters and printers.
These parameters are set in the [ Plot/Print ] menu.
3-
The SOURCE connector outputs the analyzer's
source signal. An LED on the front panel
indicates if the source is on or off. The source
parameters are set in the [ Source ] menu.
The standard Agilent 35670A (2-channel) also has
a source connector on the front panel.
4-
The EXT TRIG connector links the analyzer to
an external trigger signal. The external trigger
parameters are set in the [ Trigger ] menu.
5-
The TACH connector links the analyzer to a
tachometer. The tachometer parameters are set in
the [ Input ] menu.
6-
The KEYBOARD connector attaches an
optional keyboard to the analyzer.
7-
The DC POWER connector accepts DC power
levels from 12 - 28 Vdc (nominal).
8-
The AC POWER connector accept a wide range
of ac voltage levels.
9-
The POWER SELECT switch determines
whether the analyzer is powered via the AC
POWER connector or the DC POWER connector.
10-
The EXT MONITOR port links the analyzer
to multi-sync monitors.