To Measure Frequency Response - Swept Sine (Option 1D2); Option Ay6 - Agilent Technologies 35670A Quick Start Manual

Making Measurements
To measure frequency response — Swept Sine (Option 1D2)
Swept Sine measurements are available only with those Agilent 35670A analyzers
that are equipped with Option 1D2. The measurement range expands to 130 dB
(typical), but measurement time increases as compared to the FFT instrument mode.
1
Initialize the analyzer.
Press [
Press [
2
Connect the device-under-test (DUT).
3
Select the measurement parameters.
Press [
Press [
sweep.
Press [
Source

Option AY6

Source
32
] [ ].
Preset
DO PRESET
].
SWEPT SINE
] [ ] <number> <unit>, then press [
Freq
START
], then press [
RESOLUTN SETUP
] [ ] <number> <unit>.
Source
LEVEL
Rear Panel
Agilent 35670A Quick Start Guide
] <number> <unit>.
STOP
] to highlight
SWEEP LIN LOG
Channel 1
Channel 2
for a linear
LIN
Channel 1
Channel 2