To Setup Your Plotter - Serial - Agilent Technologies 35670A Quick Start Manual

Agilent 35670A Quick Start Guide
To setup your plotter — Serial
1
Connect the serial ports of your plotter and analyzer with a RS-232-C cable.
2
Check the plotter's documentation to verify the serial configuration.
3
Turn on the plotter.
4
To set the plotter's baud rate on the analyzer, press [
] [ ]. The softkey steps through the available values.
SETUP BAUD RATE
5
In the same menu, set the transmitter's (the analyzer's) handshake pacing type. Press
[ ]. The softkey steps through the available values.
XMIT PACE
6
Set the other parameter values, if you need to change the settings.
The configuration is saved in non-volatile RAM. Refer to your plotter's
documentation to determine the required serial configuration. The analyzer is
considered the transmitter and the plotter is considered the receiver.
The default values should satisfy the configuration for most plotters. Additional
parameters that you can change are:
•
[ ] — specifies the number bits in each character.
BITS/CHAR
•
[ ] — specifies the number of "stop bits" sent with each character.
STOP BITS
•
[ ] — sets the parity generated for characters.
PARITY
•
[ ] — enables parity verification capability.
PRTY CHK
•
[ ] — sets the receiver handshake pacing type.
RCVR PACE
Saving and Plotting Data
] [
Plot/Print
MORE SETUP
] [
SERIAL
53