To Customize Your Analyzer - Agilent Technologies 35670A Quick Start Manual

Agilent 35670A Quick Start Guide

To customize your analyzer

Creating an AUTO_ST.STA file allows you to automatically specify a specific
measurement state when you turn on the analyzer or when you press [
[
RECALL AUTOSTATE
1
Initialize the analyzer.
Press [ ] [
Preset
DO PRESET
2
Configure the analyzer to fit your application.
3
Select the default disk, either the non-volatile RAM disk or the internal disk.
See "To select the default disk" in the second section, Setting Up.
4
Save the measurement state.
If the internal disk drive is the default disk, insert a 3.5 inch floppy disk.
Press [ ] [
Save/Recall
SAVE MORE
Press [ ].
ENTER
At power-up, the analyzer searches the internal disk drive first and then searches the
non-volatile RAM disk for the "AUTO_ST" file. If it is found, the analyzer loads the
measurement state immediately.
].
].
] [
SAVE AUTOSTATE
Automating Measurements
]
Preset
].
59