Table of Contents
Advertisement
REV.-A
1.5.5
Housing
The basic configuration of the housing is the same as that of a conventional printer. The components
mounted on the lower case are covered by the upper case. Differences between this and a conventional
case are as follows:
•
A door for replacing the ink cartridge has been added at the front of the lower case.
•
An option board cover for replacing the optional interface has been added to the upper case.
•
The printer cover is divided into two pieces, and one of them is a half-fixed type.
•
The direction of the slot for the optional cartridge was changed from vertical to horizontal.
The paper support (separator) was normally used for both cut sheets and fan-fold paper, but it should
be removed when the CSF is mounted. When the optional pull tractor is mounted, replace it with the
special separator.
Option board cover
Printer cover
Ink cartridge door
Figure 1-25.
Housing
1-48
Advertisement
Table of Contents
