Table of Contents
Advertisement
REV.-A
4.2.6.13 Paper End Sensor Removal
Step 1 Remove the platen unit. (See Section 4.2.6.11)
Step 2 Remove the two CCS screws (M3 X 6) securing the lower paper guide to the base frame, then
remove the lower paper guide.
Base frame
CCS (M3 X 6)
Figure 4-50. Lower Paper Guide Removal
Step 3 Remove the CCS screw (M3 X 8) securing the paper end sensor set, then remove the paper
end sensor set.
Studs
Paper end sensor
CCS (M3 X 8)
Figure 4-51. Paper End Sensor Set Removal
ASSEMBLY POINT:
•
When installing the paper end sensor set, confirm that the two studs of the sensor are inserted
correctly in the holes of the base frame, then tighten the screws.
4-41
Advertisement
Table of Contents
