Epson SQ-B50/2550 Technical Manual page 42

REV.-A
1.4.1.3 SelecType
This section describes the SelecType (Panel setting) function.
In the SelecType mode, default value settings can be selected using the four switches on the control
panel and messages displayed on the LCD.
• Entering the SelecType mode.
Press both the
I
ON LINE
I
and
I
FORM FEED
I
switches.
• If these switches are pressed again, the printer exits the SelecType mo,de (exits the panel setting
mode).
Values will become valid as they are set in the SelecType mode. However, the following settings will
become valid the next time the printer power is turned on.
ON/OFF of Auto LF
Valid/Invalid of DC 1/DC3
Once the values are set, they are stored in the memory, which is backed up. Since the settings will remain
even after the printer power is turned off, the values displayed on the LCD will be set as default values
the next time the printer power is turned on. Therefore, the printer has no DIP switches. Back up is
performed with a battery, and requires no maintenance.
The following page shows the operation flow in the SelecType mode.
If you want to reset the default settings to the factory set values, clear the memory as described below:
• Clearing the memory
Turn the printer power on while pressing both the
I
ON LINE
I
and
I
LOAD/EJECT
I
switches.
When the memory is cleared correctly, the following message will be displayed on
the LCD:
I
MEMORY CLEAR
Messages displayed on the LCD change in the sequence shown in the Table below, and the buzzer rings.
1-28