REV.-A
Step 11 Remove the two CB screws (M2.5 X 3) securing the TE motor, then remove the TE motor from
frame M.
Frame M
TE motor
CB (M2.5 X 3)
Figure 4-57. TE Motor Removal
ASSEMBLY POINTS:
•
Lubricate the paper feed reduction gear and top edge holder paper feed transmission gear. (See
Chapter 6)
•
When installing the TE motor, attach it so that no space exists between frame M and the stopper
of the base frame.
ADJUSTMENT REQUIRED
After replacing the TE motor, the following adjustments are required:
• TE sensor roller position adjustment (See Section 4.3.2)
• Carriage timing belt tension adjustment (See Section 4.3.3)
• Platen gap adjustment (See Section 4.3.4)
• Printing position alignment (See Section 4.3.5)
NOTE: When you want to remove only the paper guide plate set and you have a 5.5 mm hexagonal
wrench, you can omit steps 1 through 4.
Hexagonal wrench
Figure 4-58. Paper Guide Plate Removal
4-45