Table of Contents
Advertisement
REV.-A
4.2.6.9 Home Position Sensor Removal
Step 1 Remove the upper case. (See Section 4.2.2.1)
Step 2 Move the carriage to the center of the platen.
Step 3 Cut the wire band securing the home position sensor to the Frame L.
Step 4 Remove the home position sensor from frame L, then pull out the lead wire connector.
Frame L
/
Lead wire
Wire band
/
Home position sensor
Figure 4-42. Home Position Sensor Removal
NOTE: Be careful not to stress the lead wire of the home position sensor.
ASSEMBLY POINT:
•
Install the wire band securing the home position sensor so that the cable clamping section comes
outside of frame L. (See Figure 4-42)
4-35
Advertisement
Table of Contents
