REV.-A
NOTE 1: When executing push-pull feed with the pull tractor mounted, the paper load/eject function
cannot be used because the paper comes out the pull side each time a back out is executed.
(For details, see Chapter 3.)
NOTE
2:
When the paper is loaded, the default TOF position is 8.5 mm from the top edge of the paper.
(This is factory set.)
1.4.1.9 TOF Adjustment FOnction
The TOF position can be adjusted (set to any position) just after the paper is loaded (NOTE
1)
by using
the MICRO FEED switch on the control panel. Once the TOF value is set, it is stored in the memory, and
remains in effect even after the printer power is turned off.
When the MICRO FEED switch is pressed;
I
TOF ADJUST
The message shown above is displayed on the LCD. Since a TOF value can be set
for four types of paper as shown below, it is not necessary to check the value
after changing the paper type. (The right side indicates the TOP range.)
•
Cut sheet (NOTE 2)
•
Fan-fold paper
•
Paper for the single-bin CSF
•
Paper for the double-bin CSF
: 8.5 to 27.5 mm
: 8.5 to 34 mm
: 8.5 to 34 mm
: 8.5 to 34 mm
During micro adjustment, the buzzer rings at 8.5 mm and 22 mm from the top edge
of the paper to indicate these reference positions.
NOTE 1: If printing or paper feeding is executed after loading the paper, the printer cannot enter the
TOF adjustment mode.
NOTE 2: When loading the paper from the sheet guide without the CSF mounted.