Table of Contents
Advertisement
REV.-A
1.4.1.8 Paper Load/Eject Function
WARNING
• Do not turn the manual paper feed knob, unless a paper jam occurs. The reasons are as
follows:
Usually, reverse paper feeding is prohibited by the software to prevent the paper from being
smudged. If the feed knob is operated manually, this protection is overriden.
Positions set in the SelecType mode, such as TOF or tear off positions, will be shifted .
• Never feed the paper in the reverse direction when printing labels. Otherwis a label might
adhere to the printer.
Paper handling in this printer is completely automated. By pressing the corresponding switch on the
control panel, the printer executes as follows:
•
Loading/ejecting a cut sheet
1. Set a cut sheet at the sheet guide.
2. Press the
I
LOAD/EJECT
I
switch.
1
When the printer is in the paper out state: Loads
the paper
(advances the paper to the TOP position, then
stops).
When the paper is in the printer: Ejects the
paper.
1
When the printer is in the paper out state:
Loads the paper (advances to the TOF position,
then stops).
When the paper is in the printer: Executes back
out.
(Back out: Feeds the paper in the reverse direction, then ejects it.)
•
Loading/ejecting fan-fold paper
1. Set the paper at the sprockets of the tractor.
2. Press the
I
LOAD/EJECT
I
switch.
•
Switching between tractor and friction feed (cut sheet/CSF) mechanisms
Switching from the tractor to the friction mechanism
1. Press the PAPER SELECT switch.
2. Back out the fan-fold paper.
3. Cancel the push tractor mechanism, then select the friction mechanism.
4. Load the paper from the sheet guide or the CSF.
Switching from the friction to the tractor mechanism
1. Press the PAPER SELECT switch.
2. Eject the cut sheet.
3. Cancel the friction mechanism, then select the push tractor mechanism.
4. Load the fan-fold paper set at the push tractor.
1-35
Advertisement
Table of Contents
