Table of Contents
Advertisement
REV.-A
1.4.1.10 Tear Off Function
The tear off function matches the position to be cut (paper bail position) with the perforation for
tearing-off the fan-fold paper. This function has two modes, manual and automatic.
•
The paper can be fed to the paper cut position (tear off position) as follows:
Manual mode
Press the I-=T=E:-::-A-=R-O=-:F=F=-I switc h.
Automatic mode
Select"AUTO TEAR OFF ON" in the SelecType mode. This function will be valid only when the following
conditions are met. (The auto tear off function will be ignored if any of the following conditions is not
met.)
No data is being received from the host computer after printing is completed.
The waiting position at that time is the TOF position of the paper.
•
When the tear off function is started in either the manual or auto mode, the printer advances the
perforation to the paper bail position, and displays the following message on the LCD.
I
PLEASE TEAR OFF
•
After the paper is torn off, it is returned to the original position regardless of the mode (manual or
auto), in any of the following cases:
When the I TEAR OFF I switch is pressed.
When the printer is set
I
ON LINE
I
by pressing the ON LINE switch.
When print data is received from the host computer.
In the tear off mode, the tear off position can be adjusted using the MICRO FEED
switch. The following message will be displayed on the LCD panel when the MICRO
FEED switch is pressed in the tear off mode.
I
TEAR OFF ADJUST
The value set is stored in the memory, and remains even after the printer power
is turned off. The paper is fed to the new tear off position when a tear off operation is executed after
the setting.
1-37
Advertisement
Table of Contents
