Table of Contents
Advertisement
REV.-A
4.3.5.2
Adjustment Procedure
Figures 4-65 through 4-68 show the flow charts for the adjustment programs.
Once the first step (START) is executed, the subsequent steps in the flow charts
must be executed up to the last step.
•
Start
Remove the printer cover and printer lid, insert the adjustment cartridge in optional cartridge slot
A, and turn the printer power on.
•
Basic operation
• To skip an adjustment item: Press the MICRO FEED switch.
•
To execute an adjustment item: Press the LOAD/EJECT switch.
NOTE:
Select either the 80-or 136-column model. (Since the PROM used is common to both the 80-and
136-column models, this mode must be reset each time the adjustment is started so that the
PROM can identify the model type to be adjusted.)
Press MICRFEED
"7
switch
ENTER
SKIP
Figure
4-65.
Main Flow Chart
4-53
Advertisement
Table of Contents
