Enable Radius - M86 Security M86 User Manual

WF G A
LOBAL DMINISTRATOR
182
S C
ECTION HAPTER

Enable Radius

The Radius Mode is "Off" by default. To use Radius, click
the "On" radio button. This action displays the Radius
Authentication Settings frame.
Specify Radius Authentication Settings
1. In the Radius Server field, 1.2.3.9 displays by default.
Enter the IP address of the Radius accounting server.
2. In the Radius Port number field, 1813 displays by
default. Change this number only if the Radius
accounting server uses a different port number.
3. In the Byte Order Mode field, specify the format in which
bytes will be transferred:
• Click the radio button corresponding to Network Byte
Order to transfer the most significant byte first.
• Click the radio button corresponding to Host Byte
Order to use the byte order stored in the server (big
endian or little endian order).
NOTE: The byte order should match the setting on the Radius
accounting server.
4. In the Forward Mode field, specify whether accounting
request packets will be delivered from the client (NAS or
proxy server) to the Radius accounting server.
To enable the Forward Mode option:
• Click the "On" radio button. The NAS will forward
accounting request packets to the Radius accounting
server.
• Check the box for Use Web Filter IP as Source IP, if
the IP address of the Web Filter (LAN1 or LAN2)
should be used when forwarding packets instead of
the IP address of the NAS.
1: S
YSTEM SCREEN
M86 S U G
ECURITY SER UIDE